![]() Sudo apt-get install minicom gpsd gpsd-clients Before that, however, we need to update the repositories. We need a few programs to read the Raspberry Pi GPS module. This can also be done after installing the other software. Your file should look like this: dwc_otg.lpm_enable=0 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline rootwaitįor the changes to be accepted, a restart is absolutely necessary. ![]() The last entry does not seem to exist in all OS versions by default. The following entries are deleted: console=ttyAMA0,115200 kgdboc=ttyAMA0,115200 Then there is the file /boot/cmdline.txt to be edited, sudo nano /boot/cmdline.txt Storing is done with STR + O, finished with CTRL + X. ![]() Here the following line (presumably the last one) has to be commented out (or deleted) by means of a rhombus # at the beginning. For this we edit the following file: sudo nano /etc/inittab If you have not already released the serial interface before, this must happen beforehand. The wiring is very simple: GPS Modul Raspberry Pi VCC 3.3V (Pin 1) RX TXD/GPIO 14 (Pin 8) TX RXD/GPIO 15 (Pin 10) GND Ground (Pin 6) 10000mAh Powerbank (alternatively follow this tutorial).In this tutorial, I’ll show you how tracking works with such a GPS module and what you need for it. Mobility is achieved with a battery pack or a USB power bank. ![]() ![]() In many outdoor applications, especially those that move (Car-PC, weather balloon, etc.), the exact position is a big advantage. While every smartphone has GPS, the Pi can also be converted into a GPS receiver with a cheap Raspberry Pi GPS module. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |